The D trim is a fillet of trim for use against abutting walls. It will also provide expansion and perimeter ventilation and is compatible with C2 and C3 universal corners. Place the D trim against the vertical face and push down diagonally into the corner until the trim fits snugly. Where the D trim needs to be joined it should be bonded with a strip polyurethane adhesive and bandaged together. The C trim is usually fitted into a bed joint of the brickwork or a 35/50mm (depending on the trim type) deep chase cut out with an angle grinder fitted with a mortar chase disc. Apply polyurethane adhesive to the back of the C trim every 300mm. Fit the trim into the slot and press firmly back to the wall to overlap the D trim. Apply a clear silicone sealant along the length of the trim into the slot to seal the trim in. A smooth finish can be obtained by wiping the sealant with a moistened finger.
Trim name:
D260
Dimensions:
Girth: 260mm; Fillet: 135mm & 70mm; Upstand height: 120mm
Application:
Asymmetric fillet trim for use against abutting walls.
Also provides expansion and perimeter ventilation.
Please send us a message below with your telephone number. Shipping agents & couriers insist on a contact number.
Trim name:
D300 Long Flange
Dimensions:
Girth: 260mm; Fillet: 175mm & 70mm; Upstand height: 120mm
Application:
Extra wide asymmetric fillet trim for use against abutting walls.
Also provides expansion and perimeter ventilation.
Please send us a message below with your telephone number. Shipping agents & couriers insist on a contact number.
