A170/A200/A250 – Drip Trims

The A type trim is a drip trim, fitted to the lowest edge of the roof usually where the rainwater flows into the gutter. Two support battens should be fixed to the perimeter of the roof to provide space for the gutter to fit behind the trim, with the outer batten attached 10mm lower than the inner batten to allow the trim to sit flush with the roof. Apply trim adhesive to the batten in 30mm beads at 300mm centres, rub the trim into place and nail to the decking. Do not nail through the front of the trim. If the pitch of the roof is only minimal, rainwater is likely to hold behind the trim. A planning machine can be used to take 2mm off the deck to allow the trim to lay flush with the board.

Trim name:
A170

Dimensions:
Girth: 170mm; Depth: 65mm

Application:
Fitted to roof edges to allow drainage.




Please send us a message below with your telephone number.                 Shipping agents & couriers insist on a contact number.

Trim name:
A200

Dimensions:
Girth: 200mm; Depth: 90mm

Application:
Fitted to roof edges to allow drainage into gutter.
Compatible with C1, C2 and C4 corner trims.




Please send us a message below with your telephone number.                 Shipping agents & couriers insist on a contact number.

Trim name:
A250

Dimensions:
Girth: 250mm; Depth: 140mm

Application:
Roof edge detail to cover insulation.
Usually used with a warm roof specification.
Deep fascia to allow gutter penetration.




Please send us a message below with your telephone number.                 Shipping agents & couriers insist on a contact number.